How to Make Fixes in Your House

If you want to get several tips for your home repair, read these important steps:
Slamming Door
Soften the slam of a door by affixing several bits of peel-and-stick foam weather stripping round the doorstop. Or get yourself a wide elastic band and wrap it round the doorknobs on both sides, stretching it over the edge of the entranceway. Don’t cover the latch.
home-repairSqueaky Door Hinges
Spray just a little WD-40 onto the hinges, moving the entranceway backwards and forwards to work in the lubricant. Or try rubbing the hinges with vaseline. If these tricks don’t work, lift the hinge pins about halfway and lubricate them with three-in-one oil, utilizing a rag to catch drips.
Dusty Chandelier
Permit the fixture to cool. Wear a couple of white cotton gloves - one dry, one dampened with glass cleaner. (For crystal, use one part rubbing alcohol to three parts distilled water.) Wipe each prism with the damp glove, then your dry one.
Stained Tub
Combine equal levels of cream of tartar and baking soda with enough lemon juice to create a paste. Rub the mixture in to the stain together with your fingers or perhaps a soft cloth. Let sit for a half hour, then rinse well with water.
Worn Caning
Just a little sagging as time passes is natural but reversible. To tighten caning back up, work with a sponge to wet the lower with tepid to warm water. Let dry slowly overnight. Repeat if necessary.
Squeaky Floor
For a temporary fix, sprinkle talcum powder on the noisy area and sweep it in to the cracks. Make sure to remove any traces of powder if you’re ever likely to refinish the ground.
Peeling Wallpaper
With a knife, smear wallpaper paste onto a bit of writing paper. Rub the paper contrary to the underside of the peeling section. Press the wallpaper contrary to the wall. Slide the writing paper out and smooth away bubbles with a clean cloth.
Stuck Sliding Windows
Just a little silicone spray lubricant (sold at hardware stores) will grease the skids. Spray it onto a rag, then wipe across the tracks, whether they’re metal, wood, or plastic.
Dry Cutting Board
Revive your board by gently warming a bottle of pure mineral oil (offered by drugstores) in a plate of warm water, then wiping the oil onto the top with a soft cloth. Wipe off the surplus 4-6 hours later.
Scuffed Linoleum
Rub the location with white toothpaste and a dry cloth or having an eraser. Or spray WD-40 on a towel and rub lightly, making certain to degrease the region afterward with liquid dishwashing soap and water.